Altana Byko-Drive Manual Manuel d'utilisateur télécharger pdf (Page 15)

English

Operation

Once the substrate is held in place, position an

appropriate Bird applicator, wire rod, square appli-

cator or other applicator bar in front of the Pushbar.

To keep wire rods from rotating and when additio-

nal weight is needed for other applicators, set the

Weight over the pins of the Pushbar allowing the

rubber strips to hold the applicator in place. The

narrow space is for 10 mm diameter rods, the wider

space is for 1/2” (12.6 mm) diameter rods.

Apply an appropriate amount of coating immediate-

ly in front of the applicator. Press the forward button

and the application will begin.

At the end of the travel, the Applicator will stop au-

tomatically. Remove the applicator for cleaning and

press the Reverse button. Once the carriage has

returned to the start position, remove the coated

substrate.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Altana Byko-Drive Manual Manuel d'utilisateur Page 15