Altana Micro-Wave-Scan Manual Manuel d'utilisateur télécharger pdf (Page 15)

Power supply

3. Power supply

Beforeoperatingtheinstrumentfortherst

time, please read the operating manual and

takeparticularnoticeoftheSafetyInstructions.

Unpack the instrument and check the delivery for

completeness(Seechapter“DeliveryNotes”).

Powering the instrument

The measurement unit can be operated either with

rechargeable battery pack included with delivery or

with AA (LR6) alkaline batteries.

Battery:

To operate the instrument using batteries, the

batterycompartmentmustbettedwithtwo1.5-V

mignon AA(LR6) batteries and must be inserted

into the measurement unit until it locks into place.

Ensure that the batteries are

correctly oriented in the compartment

according to the (+) and (-) marks. See adjacent

gure.

Use only alkaline batteries (AA /LR6)!

Dependingonthespecicbrand,thecapacity

ofthebatteryincludedwithdeliveryissufcient

for about 1000 measurements. When the battery

voltage falls below the required operating voltage

in the course of operation, the following message

appears on the display:

  “LowBattery!”

To ensure that the instrument is always ready for

operation, it is recommended to have the battery

compartment and spare batteries handy, especially

whenperformingmeasurementsintheeld.

Rechargeable battery pack

Battery compartment

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Pas de commentaire

Altana Micro-Wave-Scan Manual Manuel d'utilisateur Page 15