Altana Byko-Test MP0R Manuel d'utilisateur télécharger pdf (Page 19)

9 Deleting a calibration / Restoring the baseline of the characteristic

Sometimes, if an instrument does not measure correctly even after a calibration, the calibration can be deleted.

This can occur if the previous calibration has not been carried out correctly.

In such a case, the baseline of the characteristic can be restored to its original factory condition.

Note to users of the DUALSCOPE



MP0R (instrument version with two measurement channels): the base line of

each of the two measurement channels must be restored separately (Fe Base and Al Base required).

Deleting the calibration of the instrument: (Instructions continued on next page)

Prerequisite: Instrument is switched ON.

1. Select the menu option (i.e., calibration) using button [] or [].

2. Press button [OK]. "Base" (i.e., “substrate material”) will appear on the display.

The instrument is now in calibration mode.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Pas de commentaire

Altana Byko-Test MP0R Manuel d'utilisateur Page 19