Altana BYK-mac i COLOR Manual Manuel d'utilisateur télécharger pdf (Page 20)

Calibrate

Calibration Notes

• Dirt or dust in the optics area will cause an

inaccurate calibration reading. Therefore, always

use the protective cap, if no readings are taken.

• The standards and black trap should be cleaned

periodically. For cleaning procedure see section

"Cleaning and Maintenance“. Please make sure

that the standards are not scratched.

• The cyan tile is to some extend temperature

dependent.Therefore, make sure to perform

calibration and cyan check in laboratory

environment: temperature (20 – 25°C) and

humidity (30 – 60%) controlled.

• Do not move the instrument while taking a

calibration measurement. If motion is detected,

an error message will be displayed and

calibration is aborted.

• When moving from cold to warm environment,

there is a danger of condensation. For this

reason, you should wait for an appropriate

amount of time to allow the optical components

to adjust before calibrating and using the unit.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 60 61

Pas de commentaire

Altana BYK-mac i COLOR Manual Manuel d'utilisateur Page 20