Altana Temp-Chart Manuel d'utilisateur télécharger pdf (Page 133)

temp-chart Software temp-gard Hardware

The Command Critical Values in the Index-tab Analysis at the Lower Screen Margin

Use this command to look at the Critical Values Analysis Page.

The table of results consists of eight columns:

No. for the sensor number

Sensor for the name of the sensor

Min indicates for how long the curve was above the minimal threshold value

Low indicates for how long the curve was above the lower threshold value

Mid indicates for how long the curve was above the mean threshold value

High indicates for how long the curve was above the upper threshold value

Max indicates for how long the curve was above the maximum threshold value

Eqv. Time Indicates the corresponding equivalent heating time (see Equivalent

Time)

Please also see the chapter Sorting of Analysis Tables.

The first two lines show the set threshold values and duration times. To change them,

please use the critical values page in the setup notebook.

The Command Values in the Index-tab Analysis at the Lower Screen Margin

Use this command to look at the Critical Values in the Analysis Page. As this table is

showing individual values, it can sometimes be very long. This is why you are given the

opportunity to select a smaller range and/or a new sampling interval.

If you click on the option box Show Equivalent Holding Time, each column will not only

show the temperature value, but also the time of this temperature value taken as a basis

to calculate the equivalent time. This value is only important for very special analysis

tasks.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 146 147

Pas de commentaire

Altana Temp-Chart Manuel d'utilisateur Page 133