Altana Auto-Chart Manuel d'utilisateur télécharger pdf (Page 11)

3. Take measurements with the instrument

First select the parameters for identification of the object to be measured.

The selection procedure is guided on the instrument display and depends on the

instrument type (for further details please refer to the manual of your instrument):

After all parameters have been selected, the name of the first checkzone will be displayed.

Ready for measurement:

Measure all checkzones in order as displayed on the instrument.

Note that the readings can be influenced by the measurement direction, e.g. when

measuring vertical areas. Thus, it is recommended to measure the checkzones allways in

same orientation.

After finishing the complete test sequence, the parameter menu will apear in the display

for selection of a next object.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 203 204

Pas de commentaire

Altana Auto-Chart Manuel d'utilisateur Page 11